Table of Contents
Advertisement
9.13 Administration of Peer Clusters Not
Functional
This problem is normally caused by the BCC Administrator user not having file system rights to the
cluster administration files. See
Credentials" on page
78.
9.14 A Resource Does Not Migrate to a Peer
Cluster
If you cannot migrate a resource from one cluster to a peer cluster, the problem might be caused by
one of the following conditions:
The resource has not been BCC-enabled.
Remote clusters cannot communicate.
See
Section 9.12, "Peer Cluster Communication Not Working," on page
Syslog shows error 1019 (NSMI error).
There could be a partial script in
there is a partial script, NSMI is experiencing an error and not communicating with the SAN to
make disks visible. One reason for this is that the script might have a single % character in it
that needs to be an escape (%% instead of %). For example, hashes in Perl need to have escape
characters.
9.15 A Resource Cannot Be Brought Online
If you cannot bring a BCC-enabled resource online, it is possible the resource might be set as
secondary. If the NCS:BCC State attribute is equal to 1, the resource is set to secondary and cannot
be brought online.
On the resource object, change the NCS:BCC State attribute to 0 to set the resource to the primary
state. Also, increment the NCS:Revision attribute one number so that Novell Cluster Services
recognizes that the resource properties have been updated. See
how to modify object attributes.
9.16 Dumping Syslog on NetWare
The command
log +dump syslog
command has limited use because only the last few entries of the log can be viewed.
You can use the
log +copy syslog
Edit utility to view it. The output file that syslog is copied to is displayed after the command is
executed.
Enter
at the NetWare server console to get additional information on syslog.
log help
9.17 Slow Failovers
Failovers might be slow because the resource is slow to go offline on the source cluster. This can
happen if the failover occurs during a time when file I/O is taking place on the cluster.
"Verifying BCC Administrator User Trustee Rights and
. The scripts are named
sys:/tmp
sends the output of the syslog to the console screen. This
command to copy the syslog to a file and then use the NetWare
Troubleshooting Business Continuity Clustering 1.1 109
108.
NSMIT-######.tmp
Step 1 on page 108
for an example of
. If
Advertisement
Table of Contents
Need help?
Do you have a question about the BUSINESS CONTINUITY CLUSTERING 1.1 SP2 - ADMINISTRATION and is the answer not in the manual?
Questions and answers