Set Up A Client-To-Gateway Vpn Configuration; Step 1: Configure The Client-To-Gateway Vpn Tunnel - NETGEAR DGN2200v1 User Manual

See
• Use Manual Policy to Configure VPN Tunnels
and its VPNC defaults are not appropriate for your special circumstances and you have to
specify each phase of the connection. You manually enter all the authentication and key
parameters. You have more control over the process; however, the process is more
complex, and there are more opportunities for errors or configuration mismatches
between your DGN2200 and the corresponding VPN endpoint gateway or client
workstation.
NETGEAR publishes additional interoperability scenarios with
Note:
various gateway and client software products. Look on the
NETGEAR website at
scenarios.

Set Up a Client-to-Gateway VPN Configuration

Setting up a VPN between a remote PC running the NETGEAR ProSafe VPN Client and a
network gateway involves these two steps:
•

Step 1: Configure the Client-to-Gateway VPN Tunnel

the VPN Wizard to configure the VPN tunnel between the remote PC and network
gateway.
• Step 2: Configure the NETGEAR ProSafe VPN Client
configure the NETGEAR ProSafe VPN Client endpoint.
IP: 192.168.3.1
Figure 19. Client-to-gateway VPN tunnel
Step 1: Configure the Client-to-Gateway VPN Tunnel
This section describes using the VPN Wizard to set up the VPN tunnel using the VPNC
default parameters listed in
by these VPNC-recommended parameters, see
on page 118 for information about how to set up the VPN tunnel.
Circumstances
98 | Chapter 8. Virtual Private Networking
www.netgear.com
22.23.24.25
on page 97. If you have special requirements not covered
Table 4
N300 Wireless ADSL2+ Modem Router DGN2200
on page 125 when the VPN Wizard
for these interoperability
on page 98 describes how to use
on page 101 shows how to
VPN tunnel
Internet
Set Up VPN Tunnels in Special
0.0.0.0
PC running NETGEAR
ProSafe VPN Client