How To Set Up A Client-To-Gateway Vpn Configuration; Step 1: Configuring The Client-To-Gateway Vpn Tunnel On The Dg834G V3 - NETGEAR DG834Gv3 - 54 Mbps Wireless ADSL Firewall Modem Reference Manual

How to Set Up a Client-to-Gateway VPN Configuration

22.23.24.25
DG834G
192.168.3.1
PCs
Figure 7-3
Setting up a VPN between a remote PC running the NETGEAR ProSafe VPN Client and a
network gateway involves the following two steps:
• "Step 1: Configuring the Client-to-Gateway VPN Tunnel on the DG834G v3" on page 7-7
uses the VPN Wizard to configure the VPN tunnel between the remote PC and network
gateway.
• "Step 2: Configuring the NETGEAR ProSafe VPN Client on the Remote PC" on page 7-12
configures the NETGEAR ProSafe VPN Client endpoint.
Step 1: Configuring the Client-to-Gateway VPN Tunnel on the
DG834G v3
Note: This section uses the VPN Wizard to set up the VPN tunnel using the VPNC
default parameters listed in
not covered by these VPNC-recommended parameters, refer to
VPN Tunnels in Special Circumstances" on page 7-38
The worksheet below identifies the parameters used in the following procedure. A blank
worksheet is at "Planning a VPN" on page
Virtual Private Networking
Reference Manual for the ADSL Modem Wireless Router DG834G
VPN Tunnel
Table 7-2 on page
7-4.
v1.0, January 2006
0.0.0.0
PC
(Running NETGEAR
ProSafe VPN Client)
7-5. If you have special requirements
"How to Set Up
to set up the VPN tunnel.
7-7