Setting Up A Client-To-Gateway Vpn Configuration - NETGEAR DG834G 54 Mbps Wireless ADSL Firewall DG834G DG834G User Manual

• Use the VPN Wizard to configure a VPN tunnel (recommended for most situations):
– See "Setting Up a Client-to-Gateway VPN Configuration" on page
– See "Setting Up a Gateway-to-Gateway VPN Configuration" on page
• See "Using Auto Policy to Configure VPN Tunnels" on page 6-32
its VPNC defaults (see
want to automate the Internet Key Exchange (IKE) setup.
• See "Using Manual Policy to Configure VPN Tunnels" on page 6-42
and its VPNC defaults (see
you must specify each phase of the connection. You manually enter all the authentication and
key parameters. You have more control over the process; however, the process is more
complex, and there are more opportunities for errors or configuration mismatches between
your DG834Gv5 and the corresponding VPN endpoint gateway or client workstation.
Note: NETGEAR publishes additional interoperability scenarios with various
gateway and client software products. Look on the NETGEAR website at
www.netgear.com

Setting Up a Client-to-Gateway VPN Configuration

Setting up a VPN between a remote PC running the NETGEAR ProSafe VPN Client and a
network gateway involves these two steps:
• "Step 1: Configuring the Client-to-Gateway VPN Tunnel on the DG834Gv5" on page 6-6
describes how to use the VPN Wizard to configure the VPN tunnel between the remote PC and
network gateway.
• "Step 2: Configuring the NETGEAR ProSafe VPN Client on the Remote PC" on page 6-10
shows how to configure the NETGEAR ProSafe VPN Client endpoint.
Virtual Private Networking
Wireless ADSL2+ Modem Router DG834G User Manual
Table 6-2) are not appropriate for your special circumstances, but you
Table 6-2) are not appropriate for your special circumstances and
for these interoperability scenarios.
v1.0, May 2008
6-5.
6-18.
when the VPN Wizard and
when the VPN Wizard
6-5