NETGEAR DGN2200v1 User Manual page 120

The ping IP address has to be associated with the remote endpoint. You have to use the
remote LAN address. This IP address will be pinged periodically to generate traffic for the
VPN tunnel. The remote keep-alive IP address needs to be covered by the remote LAN
IP range and to correspond to a device that can respond to a ping. The range should be
made as narrow as possible to meet this objective.
VPN Auto Policy Local LAN Settings
The remote VPN endpoint needs to have these IP addresses entered as its remote
addresses.
Subnet Mask. The network mask.
•
Single/Start IP Address. Enter the IP address for a single address, or the starting
•
address for an address range. A single address setting is used when you want to make a
single server on your LAN available to remote users. A range has to be an address range
used on your LAN. Any. The remote VPN endpoint might be at any IP address.
Finish IP Address. For an address range, enter the finish IP address. This needs to be
•
an address range used on your LAN.
VPN Auto Policy Remote LAN Settings
The remote VPN endpoint has to have these IP addresses entered as its local addresses.
IP Address. If there is no LAN (only a single PC) at the remote endpoint, select Single
•
PC - no Subnet option. If this option is selected, no additional data is required. The
typical application is a PC running the VPN client at the remote end.
Single/Start IP Address. Enter an IP address that is on the remote LAN. You can use
•
this setting when you want to access a server on the remote LAN.
For a range of addresses, enter the starting IP address. This needs to be an address
-
range used on the remote LAN.
Any. Any outgoing traffic from the computers in the Local IP fields triggers an
-
attempted VPN connection to the remote VPN endpoint. Be sure you want this option
before selecting it.
Finish IP Address. Enter the finish IP address for a range of addresses. This has to be an
•
address range used on the remote LAN.
Subnet Mask. Enter the network mask.
•
VPN Auto Policy IKE Settings
Direction. This setting is used when the modem router determines if the IKE policy
•
matches the current traffic. Select an option.
Responder only. Incoming connections are allowed, but outgoing connections are
-
blocked.
Initiator and Responder. Both incoming and outgoing connections are allowed.
-
Exchange Mode. Ensure that the remote VPN endpoint is set to use Main Mode.
•
120 | Chapter 8. Virtual Private Networking
N300 Wireless ADSL2+ Modem Router DGN2200