Table of Contents
Advertisement
How to Set Up a Client-to-Gateway VPN Configuration
22.23.24.25
DG834G
192.168.3.1
PCs
Figure 8-3
Setting up a VPN between a remote PC running the NETGEAR ProSafe VPN Client and a
network gateway involves the following two steps:
•
"Step 1: Configuring the Client-to-Gateway VPN Tunnel on the DG834GSP" on page 8-7
the VPN Wizard to configure the VPN tunnel between the remote PC and network gateway.
•
"Step 2: Configuring the NETGEAR ProSafe VPN Client on the Remote PC" on page 8-12
configures the NETGEAR ProSafe VPN Client endpoint.
Step 1: Configuring the Client-to-Gateway VPN Tunnel on the
DG834GSP
Note: This section uses the VPN Wizard to set up the VPN tunnel using the VPNC
default parameters listed in
not covered by these VPNC-recommended parameters, refer to
VPN Tunnels in Special Circumstances" on page 8-38
The worksheet below identifies the parameters used in the following procedure. A blank
worksheet is at
"Planning a VPN" on page
Virtual Private Networking
Reference Manual for the ADSL Modem Wireless Router DG834GSP
VPN Tunnel
Table 8-2 on page
8-4.
v1.0, June 2007
0.0.0.0
PC
(Running NETGEAR
ProSafe VPN Client)
8-5. If you have special requirements
"How to Set Up
to set up the VPN tunnel.
uses
8-7
Advertisement
Table of Contents
Troubleshooting
