NETGEAR DGN2200v1 User Manual page 92

The following figure shows an example of a repeater mode configuration.
Wireless PC
associated
with AP 1
DGN2200
Internet
192.168.0.1
AP 1 (parent AP in repeater mode)
Figure 16. Repeater example
To set up a repeater with wireless client association:
In this example, the modem router is the base station, but you can set it up to be the repeater
with another AP as the base station if you want.
Set up your modem router to be the base station.
1.
a. In the Wireless Repeating Function screen for your modem router, select the Enable
Wireless Repeating Function check box.
b. Select the Wireless Base Station radio button.
c. Clear the corresponding Disable Wireless Client Association check box (make
sure it is not selected).
d. Enter the MAC addresses for AP 2 and AP 3 in the Repeater MAC Address 1 and
Repeater MAC Address 2 field.
e. Click Apply.
Set up AP 2 and AP 3 to be wireless repeaters.
2.
a. In the Wireless Repeating Function screen for AP 2 and AP 3, select the Enable
Wireless Repeating Function check box.
b. Select the Wireless Repeater radio button.
c. Clear the corresponding Disable Wireless Client Association check box (make
sure it is not selected).
d. Enter the MAC addresses for your modem router in the Base Station MAC Address
field.
e. Click Apply.
Verify the following for all access points:
3.
Each access point operates in the same LAN network address range as the LAN
•
devices.
92 | Chapter 7. Advanced Settings
N300 Wireless ADSL2+ Modem Router DGN2200
AP 2 in repeater mode
PCs
AP 3 in repeater mode
Wireless PC
associated
with AP 2
Wireless PC
associated
with AP 3