Setting Up A Client-To-Gateway Vpn Configuration; Step 1: Configure The Client-To-Gateway Vpn Tunnel - NETGEAR DGND3300v2 - RangeMax Dual Band Wireless-N Modem Router User Manual

configuration mismatches between your N300 Wireless Dual Band ADSL2+ Modem
Router DGND3300v2 and the corresponding VPN endpoint gateway or client workstation.

Setting Up a Client-to-Gateway VPN Configuration

Setting up a VPN between a remote PC running the NETGEAR ProSafe VPN client and a
network gateway involves two steps, described in the following sections:
•

Step 1: Configure the Client-to-Gateway VPN Tunnel

the VPN Wizard to configure the VPN tunnel between the remote PC and network
gateway.
• Step 2: Configure the NETGEAR ProSafe VPN Client
the NETGEAR ProSafe VPN client endpoint.
IP: 192.168.3.1
Figure 51. N300 Wireless Modem Router DGND3300v2 Client-to-Gateway VPN Tunnel
Step 1: Configure the Client-to-Gateway VPN Tunnel
This section describes using the VPN Wizard to set up the VPN tunnel using the VPNC
default parameters listed in
by these VPNC-recommended parameters, see
Circumstances on page 100 for information about how to set up the VPN tunnel.
The following worksheet identifies the parameters used in this procedure. For a blank
worksheet, see Planning a VPN
Table 3. VPN Tunnel Configuration Worksheet
Parameter
Connection Name
Pre-Shared Key
Secure Association
Perfect Forward secrecy
Encryption Protocol
80 | Chapter 6. Virtual Private Networking
N300 Wireless Dual Band ADSL2+ Modem Router DGND3300v2 User Manual
22.23.24.25
Table 2 on page 79. If you have special requirements not covered
on page 78.
Value to Be Entered Field Selection
RoadWarrior
12345678
N/A
N/A
N/A
on page 80 describes how to use
on page 83 shows how to configure
VPN tunnel
Internet
Setting Up VPN Tunnels in Special
N/A
N/A
Main Mode
Enabled
DES
0.0.0.0
PC running NETGEAR
ProSafe VPN client
Manual Keys
Disabled
3DES