Set Up A Client-To-Gateway Vpn Configuration; Step 1: Configure The Client-To-Gateway Vpn Tunnel - NETGEAR DGND3700v1 User Manual

N600 Wireless Dual Band Gigabit ADSL2+ Modem Router DGND3700
When the VPN Wizard and its VPNC defaults (see
•
appropriate for your special circumstances and you have to specify each phase of the
connection, see
manually enter all the authentication and key parameters. You have more control over the
process; however, the process is more complex, and there are more opportunities for
errors or configuration mismatches between your N600 Wireless Dual Band Gigabit
ADSL2+ Modem Router DGND3700 and the corresponding VPN endpoint gateway or
client workstation.

Set Up a Client-to-Gateway VPN Configuration

Setting up a VPN between a remote PC running the NETGEAR ProSafe VPN client and a
network gateway involves two steps, described in the following sections:
•

Step 1: Configure the Client-to-Gateway VPN Tunnel

the VPN Wizard to configure the VPN tunnel between the remote PC and network
gateway.
• Step 2: Configure the NETGEAR ProSafe VPN Client
the NETGEAR ProSafe VPN client endpoint.
IP: 192.168.3.1
22.23.24.25
Figure 43. Wireless Modem Router DGND3700 client-to-gateway VPN tunnel
Step 1: Configure the Client-to-Gateway VPN Tunnel
This section describes using the VPN Wizard to set up the VPN tunnel using the VPNC
default parameters listed in
covered by these VPNC-recommended parameters, see
on page 111 for information about how to set up the VPN tunnel.
Circumstances
Use Manual Policy to Configure VPN Tunnels
on page 89. If you have special requirements not
Table 16
Virtual Private Networking
on page 89) are not
Table 16
on page 90 describes how to use
on page 93 shows how to configure
VPN tunnel
Internet
Set Up VPN Tunnels in Special
90
on page 119. You
0.0.0.0
PC running NETGEAR
ProSafe VPN client