Table of Contents
Advertisement
Updated October 31, 2007
5. Connect the other end of the character/graphics display cable to any green
Installing the guidance label
To install the label on the display unit, follow these steps:
Figure 71. Installing the guidance label
1. Insert your finger into the slit on the filter and lift up the filter A .
2. Remove the character sheet B .
3. Stick the guidance labels C on the upper and lower portions of the character
4. Reinstall the character sheet.
5. Reinstall the filter.
(12-volt) powered-USB port on the rear of the system unit. Or, connect the other
end of the character/graphics display cable to the number 4, RS-485 port on the
rear of the system unit.
C
B
A
C
sheet. Make sure that the right edge of the label aligns with the right edge of
the sheet.
Chapter 4. Installing external options
73
Advertisement
Table of Contents
