Table of Contents
Advertisement
Figure 22. Replacing the UPS retainer bracket
The following steps apply only if you installed a UPS:
10. Set the configuration (DIP) switches on the front panel of the UPS. See
32
SurePOS 700 Series: SurePOS 700-721/741/781, 722/742/782 Planning, Installation, and Operation Guide
7. Secure the expansion housing to the chassis as follows:
Important
a. Slide the left end of the retainer bracket into the notch and then insert
the right end. See Figure 22
b. Tighten the screw.
Attention:
The retainer bracket can only be installed if the expansion
housing is fully seated and latched. For safe operation, the retainer
bracket must be installed.
8. Connect the power cable to the UPS.
9. Optionally, connect the serial cable to the UPS.
"Configuration switches" on page 11 for additional information.
Updated October 31, 2007
Advertisement
Table of Contents
