Inserting The System Unit Into The Service Housing; Attaching The I/O Tray; Inserting The Unit Into The Service Housing - IBM 4800-741 Planning, Installation, And Operation Manual

Inserting the system unit into the service housing

Figure 95. Inserting the unit into the service housing
1. Complete the steps described in "Attaching the pull-out handle" on page 89.
2. On an flat surface, align the unit with the service housing.
3. See Figure 95. Place the unit in the housing and slide it backward until it stops.

Attaching the I/O tray

To attach the I/O tray, follow these instructions:
1. Complete the instructions described in "Inserting the system unit into the service
2. Position the I/O tray on top of the system unit and insert the four M3x5 screws
92
SurePOS 700 Series: SurePOS 700-721/741/781, 722/742/782 Planning, Installation, and Operation Guide
The system latch should snap into place.
housing."
( A in Figure 96 on page 93) into the tray.
Updated October 31, 2007