Table of Contents
Advertisement
Updated October 31, 2007
Top plate removal
Note: This section is provided for installation procedures that are not a part of an
To remove the top plate:
1. Remove the front bezel and top cover by following the steps in "Cover removal
Figure 41. Top plate screws
2. See Figure 41. Locate and remove the eight screws ( D ) holding the top plate.
3. Slide the cover backward and then lift upward to remove.
4. To replace, reverse these procedures.
initial setup.
procedures" on page 45.
Note: To aid installation, the holes that require a screw have an arrow imprinted
beside of them.
D
Chapter 3. Installing internal options
X8
49
Advertisement
Table of Contents
