Tokens For Request In Queue Notification Messages; Configuring A Subsytem To Send Notifications - Netscape MANAGEMENT SYSTEM 4.5 Installation And Setup Manual

Table 16-3 Tokens defined in templates used for request-rejection notifications
Token
$InstanceID
$RequestId

Tokens for Request In Queue Notification Messages

Table 16-4 lists the tokens that you can use for formulating the content of the
RequestInQueueJob
Table 16-4 Tokens for the request-in-queue job's summary report
Token
$InstanceID
$ExecutionTime
$RecipientEmail
$SenderEmail
$SummaryTotalNum

Configuring a Subsytem to Send Notifications

To configure a Certificate Manager or Registration Manager to send event-driven
notifications, follow these steps:
• Step 1. Before You Begin
• Step 2. Turn On Certificate-Issuance Notification
Description
Specifies the ID assigned to the subsystem that sent this notification.
• If the notification is sent by a Certificate Manager, this will be ca.
• If the notification is sent by a Registration Manager, this will be ra.
Specifies the request ID.
job's summary report.
Description
Specifies the ID assigned to the subsystem that sent this notification.
• If the notification is sent by a Certificate Manager, this will be ca.
• If the notification is sent by a Registration Manager, this will be ra.
Specifies the time the job (instance) was run.
Specifies the email address of the recipient.
Specifies the email address of the sender (it is the same as the one you specify in
the Sender's E-mail Address field in "Step 3. Turn on Request in Queue
Notification" on page 561).
Specifies the total number of items (certificate requests that are pending in the
queue) in the summary report.
Configuring a Subsytem to Send Notifications
Chapter 16 Setting Up Automated Notifications 559