Data Recovery Manager Configuration; Transport Certificate; Key-Pair Information For Transport Certificate - Netscape MANAGEMENT SYSTEM 4.5 Installation And Setup Manual

If you are submitting your certificate request to another Certificate Manager, you
need to know its URL:
• End-entity URL for issuing a Certificate Manager__________________________
Enter the URL for the end-entity gateway of the Certificate Manager that will issue
the Registration Manager's signing certificate. For example,
http://<hostname>:17006

Data Recovery Manager Configuration

This section summarizes information required to configure a Data Recovery
Manager (either by itself or as part of a joint installation with a Certificate Manager
or Registration Manager).
NOTE

Transport Certificate

Key-Pair Information for Transport Certificate

For a discussion of issues related to key type and length, see "CA Signing Key Type
and Length" on page 174.
• Token for storing the transport certificate signing certificate and private
key________________________________________
Enter either
external token. If you are using an external token, you will need to install it
before you run the Installation Wizard. In the wizard, you can select from a list
of already installed and available tokens. For example,
installation instructions, see "Installing External Tokens" on page 451.
• Token password_________________________________________________
The password for the token must be at least one character long.
.
If you want to use hardware tokens for generating and storing Data
Recovery Manager's key pairs, you'll need at least two tokens: one
exclusively for the storage key pair and the other for the remaining
key pairs. Be sure to install (and initialize, if required) these tokens
before you start the Data Recovery Manager installation.
(if you plan to use the internal token) or the name of an
internal
Data Recovery Manager Configuration
. For
SmartCard
Chapter 5 Installation Worksheet 203