The next step will turn on the Job Scheduler. Once the scheduler is enabled you
will receive at least two email messages every minute. Make sure you turn off
the Job Scheduler after a few minutes to avoid a flood of email messages.
Select the Enable Jobs Scheduler checkbox.
9.
Click Save.
10.
You should begin receiving email after one minute.
After the scheduler has been running for a few minutes, deselect the Enable
11.
Jobs Scheduler checkbox.
Click Save.
12.
Check your email.
13.
You will have at least two messages.
Messages with the subject "Certificate Renewal Notification" are examples of
notices sent to end entities. By default, these are sent to the address in the email
(E) attribute in the certificate subject. These messages explain that the
certificate is going to expire on a certain date, and they provide a URL for an
end-entity gateway where the certificate can be renewed.
Using the Default Demo
Chapter 3
Default Demo Installation
159
Need help?
Do you have a question about the NETSCAPE MANAGEMENT SYSTEM 4.5 and is the answer not in the manual?