Add Device From Template Window - AMX RMS CODECRAFTER Instruction Manual

RMS CodeCrafter MeetingManager Project Pages
Using communications (COMM) module? - When selected, RMS CodeCrafter includes code for
a communications module.
Module Virtual Device - Drop down lists of devices available. This field is populated by devices
extracted from the integrated NetLinx file. You can select an existing device, enter a new device, or
enter a D:P:S address. If you select None in Support Module, this control is disabled.
Communication Timeout - Measured in 1/10ths of a second, where 0 is a valid value. If no
timeout is required, use -1.
Control Failure Detect - Placing a check in the box adds a call to RMSEnablePowerFailure() in
the generated code file.
OK - Accepts changes and closes window.
Cancel - Closes window and does not keep changes.

Add Device from Template Window

If you select Add Device from Template, this window gives you the selection of all templates found
in the default folder and populates them into the grid.
FIG. 21 Add Device from Template Window
Device - A list where you can either select the device or type it in manually.
Virtual Device - A list where you can either select the communications module virtual device or
type it in manually. This field is required only when the selected device template uses a
communications module.
30
Communications Module Virtual Deivce - A combo list either populated by virtual
communication devices or you can type your own virtual device in the field.
RMS CodeCrafter