Dip Switch Configuration; Dip Switch Functions (1-8) - AMX PRO-DP8 DECOR PROLINK FLUSH MOUNT KEYPAD PANEL Instruction Manual

DIP Switch Configuration

This section describes the functionality associated with the various DIP switch settings available on
the PRO-DP8 panel. These switches determine the front panel functions and should not be thought
of as user accessible.

DIP Switch Functions (1-8)

The panel functions are set by the configuration of the DIP switch, located on the back of PRO-DP8
panel. The factory default is for all the switches to be in the Off position.
Always disconnect the PROlink cable from the PRO-DP8 to remove power before
changing DIP switch settings. Once the switche(s) are set, reconnect the PROlink
cable to the PRO-DP8 to provide power to the panel.
On power-up, the pushbutton LEDs momentarily light in sequence until the Channel 1
LED remains on.
The following table lists the operational assignments for the PRO-DP8 DIP switch.
DIP Switch Assignments
Switch On Function
1
2
3
4
5
6
7
8
PRO-DP8 Decor 8-Button Wall Panel
Bit 1 Preset Offset. Offsets panel pushbuttons by 4.
With this offset, the pushbuttons = 5-20.
Bit 2 Preset Offset. Offsets panel pushbuttons by 8.
With this offset, the pushbuttons = 9-24.
Bit 3 Preset Offset. Offsets panel pushbuttons by 16.
With this offset, the pushbuttons = 17-32.
Can select zones on 2 packs (12 zones).
Select zones starting with pack 1 (zone 1).
Preset 64+ Offset
Recall Presets only (on pushbuttons 1-8)
Program/record disable
DIP Switch Configuration
Off Function (factory default)
No offset (pushbuttons = 1-8)
No offset (pushbuttons = 1-8)
No offset (pushbuttons = 1-8)
Can select zones on 1 pack (6 zones).
Select zones starting with pack 2 (zone 7).
Preset 8+ Offset
Enables Zone Select function on pushbutton 5,
and up/down ramping on pushbuttons 6 and 7.
Program/record enable.
15