Dip Switch Configuration; Dip Switch Functions (1-8) - AMX PRO-DP16 DECOR PROLINK FLUSH MOUNT KEYPAD PANEL Instruction Manual

DIP Switch Configuration

This section describes the functionality associated with the various DIP switch settings available on
the PRO-DP16 panel. These switches determine the front panel functions and should not be thought
of as user accessible.

DIP Switch Functions (1-8)

The panel functions are set by the configuration of the DIP switch (FIG. 7), located on the back of
PRO-DP16 panel. The factory default is for all the switches to be in the Off position. Note the
orientation of the DIP switch (upside-down, relative the front panel), and remember that the arrow
printed on the DIP switch points to the On position.
Always disconnect the PROlink cable from the PRO-DP16 to remove power before
changing DIP switch settings. Once the switche(s) are set, reconnect the PROlink
cable to the PRO-DP16 to provide power to the panel.
On power-up, the pushbutton LEDs momentarily light in sequence until the Channel 1
LED remains on.
The factory default is for all of the switches to be shipped in the Off position, as shown in FIG. 7.
FIG. 7 PRO-DP16 DIP switch, located on the rear panel
The following table lists the operational assignments for the PRO-DP16 DIP switch.
DIP Switch Assignments
Switch On
1
2
3
4
5
6
7
8
PRO-DP16 Decor 16-Button PROlink Wall Panel
Bit 1 Preset Offset. Offsets panel pushbuttons by 4.
With this offset, the pushbuttons = 5-20.
Bit 2 Preset Offset. Offsets panel pushbuttons by 8.
With this offset, the pushbuttons = 9-24.
Bit 3 Preset Offset. Offsets panel pushbuttons by 16.
With this offset, the pushbuttons = 17-32.
N/A
N/A
Off = Preset 64+ offset
Preset Recall mode: recalls Presets on pushbuttons
1-16.
Program/record disable
DIP Switch Configuration
Off (factory default)
Default - no offset (pushbuttons = 1-16)
Default - no offset (pushbuttons = 1-16)
Default - no offset (pushbuttons = 1-16)
N/A
N/A
Off = Preset 12+ offset (default)
Default mode: recalls presets on pushbuttons
1-10; enables ramp level up/down on Up/Down
buttons (pushbuttons 14 and 15).
Program/record enable (default).
15