DIP Switch Configuration
Using Switches 1, 2 and 3 to Set Button Offset Values
The default setting for the DIP switch is all off. Thus, by default, there is no offset assigned to the
panel pushbuttons (1-8). Use DIP switches 1-3 to set offsets by factors of four, as shown in the
following table.
Preset Offsets Chart (for DIP Switches 1, 2, and 3)
Preset Offset DIP switch 1
0
4
8
12
16
32
48
64
FIG. 1 is an example of how the Preset Offset can be used to change the value associated with a
Preset.
DIP switches 1 - 8 Off
1
2
3
4
FIG. 1 Sample DIP switch Preset Offset
Using Switches 4 and 5 to Specify Which Pack(s) to Control
Switches 4 and 5 on the PROlink DIP switch (SW2, located on the dimmer control/Integrated
Dimmer Modules) determine which pack the PRO-DP8 communicates with. The PRO-DP8
controls up to three Packs, consisting of either Dimmer Control Cards and/or Integrated Dimmer
Modules, within a Radia Lighting system. These Pack numbers can correspond to an Integrated
Dimmer Module (like the RDD-DM4 or RDD-DM6) that is connected to the PRO-DP8 via a
PROlink cable that provides both power and communication between the two devices.
These switches allow for the selection of six or 12 channels. To access two available dimmer Packs,
you must set the PROlink DIP switches on each of the dimmer Packs to different values. The
PRO-DP8 can connect to dimmer Packs 1, 2, and 3. Set the PROlink Pack numbers that are
controlled by the individual PRO-DP8s by changing the position of DIP switches 4 and 5 to the
values indicated in the following table.
16
DIP switch 2
Off
Off
On
Off
Off
On
On
On
Off
Off
On
Off
Off
On
On
On
DIP switch 2 On, all others Off
5
6
10 14
7
11 15
8
12 16
DIP switch 3
Off
Pushbuttons = 1-8 (no offset - default)
Off
Off
Off
On
On
On
On
9 13
Preset values are now offset by 8
Result
Pushbuttons = 5-12
Pushbuttons = 9-16
Pushbuttons = 13-20
Pushbuttons = 17-24
Pushbuttons = 33-40
Pushbuttons = 49-56
Pushbuttons = 65-72
PRO-DP8 Decor 8-Button Wall Panel
Need help?
Do you have a question about the PRO-DP8 DECOR PROLINK FLUSH MOUNT KEYPAD PANEL and is the answer not in the manual?
Questions and answers