Product Information; Specifications - AMX PRO-DP8 DECOR PROLINK FLUSH MOUNT KEYPAD PANEL Instruction Manual

Product Information

The PRO-DP8 is an 8-button wall panel designed to directly control AMX Radia Lighting™
systems. It is a PROlink panel that gets its power and data from a Radia Lighting Controller
attached to the dimmer control cards. PROlink panels do not have addresses and can be chained
together with minimal setup requirements. Each wall panel provides individual control of up to 12
channels (zones) via up to 3 dimmer control cards connected to the PROlink bus.
The Decor style PRO-DP8 can store/recall Preset light levels (Presets), raise/lower light levels to
create scenes, and turn lights on/off. It fits in a single-gang wall box and is connected using a low-
voltage 4-wire cable. PROlink panels are connected directly to the dimmer controllers and work
independently from AXlink or AMX Central Controllers. It comes with a standard overlay that can
be custom engraved for special uses, and allows the removal of selected buttons if desired. The
ability to recall different Presets from different panels is done via rear panel DIP switch settings.

Specifications

Specifications
Dimensions (HWD)
Voltage
Weight
Connector
Front Panel Components:
Pushbuttons
LEDs
Overlay
Rear Panel Components:
DIP switch
PROlink LED
PROlink bus connector
Wiring
Color Availability
Mounting Options
PRO-DP8 Decor 8-Button Wall Panel
4.68" x 2.93" x 1.72" (118.7 mm x 74.4 mm x 43.6 mm)
12 VDC; 50 mA maximum per panel
3.17 oz (89.86 g)
PROlink 4-pin data/power captive-wire
Up to 8 gray rubber pushbuttons in a 4 x 2 matrix
• One per button (8 total)
• 6 Channel indicators
• 6+ indicator (2nd pack indicator)
• P (Program mode) indicator
Custom engraved; default is blank.
8-position DIP switch that sets the panel's Preset Offset values, Pack Offsets,
Preset/Channel selection, and programming features.
Green PROlink status LED indicates PROlink power/data status as follows:
• One blink every two seconds indicates power is active and PROlink
communication is working.
• Full On indicates power is active and PROlink communication is not functioning
properly.
If the PROlink LED remains On, check the connections or refer to
the Troubleshooting section on page 12.
Connects to a Radia dimmer Pack using a PROlink cable.
4-conductor, AWG #18 @1,000 feet (304.8 m) max. wire length
White or black panel with gray pushbuttons
• Wall mount fits into most standard US wallboxes
• Podium mount
Product Information
1