Prolink Status Led; Testing - AMX PRO-DP8 DECOR PROLINK FLUSH MOUNT KEYPAD PANEL Instruction Manual

Wiring and Installation
PRO-DP8
+12
PR+
PR-
GND
FIG. 2 PROlink wiring diagram using an external 12 VDC power supply
Do not connect the PWR wire to the PROlink connector's PWR (+) terminal on the
control system side of the connector.
2. Connect the PROlink connector to the panel (see the Preparing captive wires section on
page 8).
3. Check PROlink LED on the rear side of the panel. If the green LED flashes once every 2
seconds, the panel is communicating properly with the Pack. If the LED is on and not flashing,
disconnect the PROlink connector and recheck all PROlink connections; reconnect the
PROlink connector to the panel and verify the LED is flashing once every 2 seconds.

PROlink status LED

The green LED on the rear panel of the PRO-DP8 is the PROlink status LED. This LED indicates
the communication status of the panel on the PROlink bus:
!
!

Testing

The following steps describe how to test the PRO-DP8 to verify it is working properly:
1. Disconnect power from the PRO-DP8.
2. Reconnect the power supply to the panel. Check for a blinking green LED on back of the
PRO-DP8 panel to verify proper operation.
3. Press Presets 1-10 (default) to cycle through Preset lighting levels.
4. Press Off to turn lights off.
If this test fails, refer to the Troubleshooting section on page 12.
10
12 VDC power supply
PWR (+)
GND (-)
Pack 1
Flashing (once every 2 seconds) indicates that PROlink communications are working
properly.
Full-on indicates that the panel is not communicating with the PROlink bus. Check the
PROlink wiring to the Pack and to any other panels. Refer to the Troubleshooting section
on page 12 for details.
Pack 2
+12
PR+
PR-
GND
PRO-DP8 Decor 8-Button Wall Panel