SETTING THE KEYPAD TONE
Step 1
Press [ρ]-[0]. Keypad is now in the "Adjust Tone" mode.
Step 2
Pressing the [ ] key will make the keypad sounder go to higher
tones, pressing the [ ] key will make the keypad sounder go to
lower tones.
Step 3
When the desired tone is reached, press the [#] key to set this tone
and exit from the "Adjust Tone" mode.
CHANGE PARTITION – Optional
Step 1
Press [ρ]-[1].
Step 2
Press a NUMBER key between 1 and 8 to change partitions
momentarily.
Step 3
If no other key is pressed, it will go back to its standard partition in
ten seconds.
Step 4
If another key is pressed, the system will remain in the new
partition until no keys have been pressed for 60 seconds.
VIEW ALARM MEMORY
Step 1
Press [ρ]-[3].
displayed on the keypad.
Step 2
The ALARM MEMORY feature will flash those zones that created
alarms and will light steady those zones that were bypassed during
the last alarm.
TEST FUNCTION – Optional
If programmed, this function will perform a battery test, communicator test,
and/or a siren test. Alarms and reports will not be sent, unless a
communicator test is performed at which time a test signal will be sent.
Step 1
Press [ρ]-[4]. The test will be performed as programmed.
Step 2
If the siren test is performed, enter a user code to silence the siren.
OTHER KEYPAD FUNCTIONS
The zone(s) that created the last alarm will be
Page 15