Checking the Bridge LEDs
Checking the Bridge LEDs
If your bridge is not associating with the remote bridge, check the four LEDs on the back panel. You can
use them to quickly assess the unit's status. For information on using the LEDs during the installation
and alignment of the bridge antenna, refer to the "Bridge LEDs" section in the Cisco Aironet 1400 Series
Wireless Bridge Hardware Installation Guide. Click this link to browse to the Hardware Installation
Guide:
http://www.cisco.com/en/US/docs/wireless/bridge/1400/installation/guide/1400hig4.html
Figure 19-1
Figure 19-1 Bridge LEDs
1
2
Cisco Aironet 1400 Series Wireless Bridges Software Configuration Guide
19-2
shows the bridge LEDs.
Ethernet LED
Status LED
Chapter 19
3
1
2
3
Radio LED
4
Install LED
Troubleshooting
4
OL-4059-01