Cisco CISCO1401 - 1401 Router - EN Software Manual page 211

Chapter 17 Managing Firmware and Configurations
•
•
•
•
Downloading the Configuration File by Using TFTP
To configure the bridge by using a configuration file downloaded from a TFTP server, follow these steps:
Copy the configuration file to the appropriate TFTP directory on the workstation.
Step 1
Step 2 Verify that the TFTP server is properly configured by referring to the
a Configuration File by Using TFTP" section on page
Log into the bridge through a Telnet session.
Step 3
Download the configuration file from the TFTP server to configure the bridge.
Step 4
Specify the IP address or host name of the TFTP server and the name of the file to download.
Use one of these privileged EXEC commands:
•
•
The configuration file downloads, and the commands are executed as the file is parsed line-by-line.
This example shows how to configure the software from the file tokyo-confg at IP address 172.16.2.155:
BR# copy tftp://172.16.2.155/tokyo-confg system:running-config
Configure using tokyo-confg from 172.16.2.155? [confirm] y
Booting tokyo-confg from 172.16.2.155:!!! [OK - 874/16000 bytes]
Uploading the Configuration File by Using TFTP
To upload a configuration file from an bridge to a TFTP server for storage, follow these steps:
Step 1 Verify that the TFTP server is properly configured by referring to the
a Configuration File by Using TFTP" section on page
Log into the bridge through a Telnet session.
Step 2
Step 3 Upload the bridge configuration to the TFTP server. Specify the IP address or host name of the TFTP
server and the destination filename.
Use one of these privileged EXEC commands:
•
•
OL-4059-01
Ensure that the configuration file to be downloaded is in the correct directory on the TFTP server
(usually /tftpboot on a UNIX workstation).
For download operations, ensure that the permissions on the file are set correctly. The permission
on the file should be world-read.
Before uploading the configuration file, you might need to create an empty file on the TFTP server.
To create an empty file, enter the touch filename command, where filename is the name of the file
you will use when uploading it to the server.
During upload operations, if you are overwriting an existing file (including an empty file, if you had
to create one) on the server, ensure that the permissions on the file are set correctly. Permissions on
the file should be world-write.
copy tftp:[[[//location]/directory]/filename] system:running-config
copy tftp:[[[//location]/directory]/filename] nvram:startup-config
copy system:running-config tftp:[[[//location]/directory]/filename]
copy nvram:startup-config tftp:[[[//location]/directory]/filename]
17-10.
17-10.
Cisco Aironet 1400 Series Wireless Bridges Software Configuration Guide
Working with Configuration Files
"Preparing to Download or Upload
"Preparing to Download or Upload
17-11