Configuring Multiple Privilege Levels; Setting The Privilege Level For A Command - Cisco CISCO1401 - 1401 Router - EN Software Manual

Protecting Access to Privileged EXEC Commands
To disable username authentication for a specific user, use the no username name global configuration
command.
To disable password checking and allow connections without a password, use the no login line
configuration command.
Note

Configuring Multiple Privilege Levels

By default, the IOS software has two modes of password security: user EXEC and privileged EXEC. You
can configure up to 16 hierarchical levels of commands for each mode. By configuring multiple
passwords, you can allow different sets of users to have access to specified commands.
For example, if you want many users to have access to the clear line command, you can assign it
level 2 security and distribute the level 2 password fairly widely. But if you want more restricted access
to the configure command, you can assign it level 3 security and distribute that password to a more
restricted group of users.
This section includes this configuration information:
•
•

Setting the Privilege Level for a Command

Beginning in privileged EXEC mode, follow these steps to set the privilege level for a command mode:
Command
Step 1 configure terminal
Step 2 privilege mode level level command
Step 3 enable password level level password
Cisco Aironet 1400 Series Wireless Bridges Software Configuration Guide
5-6
You must have at least one username configured and you must have login local set to open a
Telnet session to the bridge. If you enter no username for the only username, you can be locked
out of the bridge.
Setting the Privilege Level for a Command, page 5-6
Logging Into and Exiting a Privilege Level, page 5-7
Purpose
Enter global configuration mode.
Set the privilege level for a command.
Specify the enable password for the privilege level.
For mode, enter configure for global configuration mode, exec for
•
EXEC mode, interface for interface configuration mode, or line for
line configuration mode.
For level, the range is from 0 to 15. Level 1 is for normal user EXEC
•
mode privileges. Level 15 is the level of access permitted by the
enable password.
For command, specify the command to which you want to restrict
•
access.
For level, the range is from 0 to 15. Level 1 is for normal user EXEC
•
mode privileges.
For password, specify a string from 1 to 25 alphanumeric characters.
•
The string cannot start with a number, is case sensitive, and allows
spaces but ignores leading spaces. By default, no password is
defined.
Chapter 5 Administering the Bridge
OL-4059-01