Table of Contents
Advertisement
Chapter 5
Administering the Bridge
If both the enable and enable secret passwords are defined, users must enter the enable secret password.
Use the level keyword to define a password for a specific privilege level. After you specify the level and
set a password, give the password only to users who need to have access at this level. Use the privilege
level global configuration command to specify commands accessible at various levels. For more
information, see the
If you enable password encryption, it applies to all passwords including username passwords,
authentication key passwords, the privileged command password, and console and virtual terminal line
passwords.
To remove a password and level, use the no enable password [level level] or no enable secret [level
level] global configuration command. To disable password encryption, use the no service
password-encryption global configuration command.
This example shows how to configure the encrypted password $1$FaD0$Xyti5Rkls3LoyxzS8 for
privilege level 2:
bridge(config)# enable secret level 2 5 $1$FaD0$Xyti5Rkls3LoyxzS8
Configuring Username and Password Pairs
You can configure username and password pairs, which are locally stored on the bridge. These pairs are
assigned to lines or interfaces and authenticate each user before that user can access the bridge. If you
have defined privilege levels, you can also assign a specific privilege level (with associated rights and
privileges) to each username and password pair.
Beginning in privileged EXEC mode, follow these steps to establish a username-based authentication
system that requests a login username and a password:
Command
Step 1
configure terminal
Step 2
username name [privilege level]
{password encryption-type password}
Step 3
login local
Step 4
end
Step 5
show running-config
Step 6
copy running-config startup-config
OL-4059-01
"Configuring Multiple Privilege Levels" section on page
Purpose
Enter global configuration mode.
Enter the username, privilege level, and password for each user.
For name, specify the user ID as one word. Spaces and quotation
•
marks are not allowed.
(Optional) For level, specify the privilege level the user has after
•
gaining access. The range is 0 to 15. Level 15 gives privileged EXEC
mode access. Level 1 gives user EXEC mode access.
For encryption-type, enter 0 to specify that an unencrypted password
•
will follow. Enter 7 to specify that a hidden password will follow.
For password, specify the password the user must enter to gain access
•
to the bridge. The password must be from 1 to 25 characters, can
contain embedded spaces, and must be the last option specified in the
username command.
Enable local password checking at login time. Authentication is based on
the username specified in Step 2.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Cisco Aironet 1400 Series Wireless Bridges Software Configuration Guide
Protecting Access to Privileged EXEC Commands
5-6.
5-5
Advertisement
Table of Contents
