Chapter 6
Configuring Radio Settings
Performing a Carrier Busy Test
Use the no form of the command to disable packet concatenation.
For best performance over your bridge links, adjust the CW-min and CW-max contention window
Note
settings to depending on the number of non-root bridges associated to each root bridge. Refer to the
"CW-min and CW-max Settings for Point-to-Point and Point-to-Multipoint Bridge Links" section on
page 13-9
for instructions on adjusting these settings.
Performing a Carrier Busy Test
You can perform a carrier busy test to check the radio activity on bridge channels. During the carrier
busy test, the bridge drops all associations with wireless networking devices for around 4 seconds while
it conducts the carrier test and then displays the test results.
In privileged EXEC mode, enter this command to perform a carrier busy test:
dot11 interface-number carrier busy
Use the show dot11 carrier busy command to re-display the carrier busy test results.
Cisco Aironet 1400 Series Wireless Bridges Software Configuration Guide
6-9
OL-4059-01