Appendix; Error And Event Messages - Cisco CISCO1401 - 1401 Router - EN Software Manual

Error and Event Messages

This appendix lists the CLI error and event messages.
an explanation and recommended action for each message.
Table D-1 Error and Event Messages
Message
Software Auto Upgrade Messages
SW_AUTO_UPGRADE-FATAL:
Attempt to upgrade software failed,
software on Flash may be deleted.
Please copy software into Flash.
SW_AUTO_UPGRADE-7-FAILURE:
dhcp_client_start_stop failed
SW_AUTO_UPGRADE-7-FAILURE:
Failed to obtain ip addr from dhcp server
SW_AUTO_UPGRADE-7-FAILURE:
boot_file_pathent creation failed
Association Management Messages
DOT11-2-RADIO_HW_RESET: Radio
subsystem is under going hardware reset
to recover from problem
DOT11-3-BADSTATE: [mac-address]
[chars] [chars] -> [chars]
DOT11-3-RADIO_OVER_
TEMPERATURE: Interface [interface]
Radio over temperature
OL-4059-01
Explanation
Auto upgrade of the software failed. The
software on the Flash memory might have
been deleted. Copy software into the
Flash memory.
Auto upgrade of the software failed due
to error in starting/stopping DHCP client
process.
Auto upgrade of the software failed.
Auto upgrade of the software failed due
to error in creation of pathent (internal
data structure).
Radio must be reset due to problem.
802.11 Association and management uses
a table-driven state machine to keep track
and transition an Association through
various states. A state transition occurs
when an Association receives one of
many possible events. When this error
occurs, it means that an Association
received an event that it did not expect
while in this state.
The bridge detected that the unit has
exceeded the radio operating
temperature.
Cisco Aironet 1400 Series Wireless Bridges Software Configuration Guide
A P P E N D I X
Table D-1 lists the errors and events and provides
Recommended Action
Copy software before rebooting the
unit.
Copy the error message exactly as it
appears and report it to your technical
support representative.
Copy the error message exactly as it
appears and report it to your technical
support representative.
Copy the error message exactly as it
appears and report it to your technical
support representative.
None.
The system can continue but may lose
the Association that generates this
error. Copy the message exactly as it
appears and report it to your technical
service representative.
Investigate and take steps to cool the
unit.
D
D-1