Table of Contents
Advertisement
Working with Configuration Files
Creating a Configuration File by Using a Text Editor
When creating a configuration file, you must list commands logically so that the system can respond
appropriately. This is one method of creating a configuration file:
Copy an existing configuration from an bridge to a server.
Step 1
For more information, see the
page
"Downloading a Configuration File by Using RCP" section on page
Open the configuration file in a text editor such as vi or emacs on UNIX or Notepad on a PC.
Step 2
Extract the portion of the configuration file with the desired commands, and save it in a new file.
Step 3
Copy the configuration file to the appropriate server location. For example, copy the file to the TFTP
Step 4
directory on the workstation (usually /tftpboot on a UNIX workstation).
Make sure the permissions on the file are set to world-read.
Step 5
Copying Configuration Files by Using TFTP
You can configure the bridge by using configuration files you create, download from another bridge, or
download from a TFTP server. You can copy (upload) configuration files to a TFTP server for storage.
This section includes this information:
•
•
•
Preparing to Download or Upload a Configuration File by Using TFTP
Before you begin downloading or uploading a configuration file by using TFTP, perform these tasks:
•
•
Cisco Aironet 1400 Series Wireless Bridges Software Configuration Guide
17-10
17-11, the
"Downloading a Configuration File by Using FTP" section on page
Preparing to Download or Upload a Configuration File by Using TFTP, page 17-10
Downloading the Configuration File by Using TFTP, page 17-11
Uploading the Configuration File by Using TFTP, page 17-11
Ensure that the workstation acting as the TFTP server is properly configured. On a Sun workstation,
make sure that the /etc/inetd.conf file contains this line:
tftp dgram udp wait root /usr/etc/in.tftpd in.tftpd -p -s /tftpboot
Make sure that the /etc/services file contains this line:
tftp 69/udp
You must restart the inetd daemon after modifying the /etc/inetd.conf and /etc/services files.
Note
To restart the daemon, either stop the inetd process and restart it, or enter a fastboot
command (on the SunOS 4.x) or a reboot command (on Solaris 2.x or SunOS 5.x). For more
information on the TFTP daemon, refer to the documentation for your workstation.
Ensure that the bridge has a route to the TFTP server. The bridge and the TFTP server must be in
the same subnetwork if you do not have a router to route traffic between subnets. Check connectivity
to the TFTP server by using the ping command.
"Downloading the Configuration File by Using TFTP" section on
Chapter 17
Managing Firmware and Configurations
17-13, or the
17-16.
OL-4059-01
Advertisement
Table of Contents
