Table of Contents
Advertisement
Table D-1
Error and Event Messages (continued)
Message
DOT11-3-RADIO_IF_LO: Interface
[interface] Radio cannot lock IF freq
DOT11-3-RADIO_RF_LO: Interface
[interface] Radio cannot lock RF freq
DOT11-3-RF_LOOPBACK_FAILURE:
Interface [interface] Radio failed to pass
RF loopback test
DOT11-3-TX_PWR_OUT_OF_
RANGE: Interface [interface] Radio Tx
power control out of range
DOT11-4-MAXERTRIES: Packet to
client [mac] reached max retries,
remove the client
DOT11-6-ASSOC: Interface [interface],
Station [char] [mac] Associated
DOT11-6-ADD: Interface [interface],
Station [mac] Associated to Parent
[mac]
DOT11-6-DISASSOC: Interface
[interface], Deauthenticating Station
[mac] [char]
DOT11-6-ROAMED: Station
[mac-address] Roamed to [mac-address]
Unzip Messages
SOAP-4-UNZIP_OVERFLOW: Failed
to unzip
Flash:/c1200-k9w7-mx.122-3.6.JA1/ht
ml/level15/ap_xxx.htm.gz, exceeds
maximum uncompressed html size
802.11 Subsystem Messages
DOT11-6-FREQ_INUSE: Radio
frequency [int] is in use
DOT11-6-FREQ_USED: Radio
frequency [int] selected
DOT11-4-VERSION_MISMATCH:
Require radio version [hex].[int], found
version [hex].[int]
DOT11-2-VERSION_INVALID:
Unable to find required radio version
[hex].[int]
Cisco Aironet 1400 Series Wireless Bridges Software Configuration Guide
D-2
Explanation
The unit cannot lock the intermediate
frequency.
The unit cannot lock the radio frequency. None.
Radio loopback test failed at startup time. None.
The unit has detected that the radio
transmit power cannot be locked within
the operating range.
A packet sent to the client has not been
successfully delivered many times, and
the max retries limit has been reached.
The client is deleted from the association
table.
A station associated to a bridge.
A station associated to a bridge.
A station disassociated from a bridge.
A station has roamed to a new bridge.
The HTTP server cannot retrieve a
compressed file in response to an HTTP
GET request because the size of the file is
too large for the buffers used in the
uncompression process.
When scanning for an unused frequency,
the unit recognized another radio using
the displayed frequency.
After scanning for an unused frequency,
the unit selected the displayed frequency.
When starting the radio, the wrong
firmware version was found. The radio
will be loaded with the required version.
When trying to re-flash the radio
firmware, the bridge recognized that the
radio firmware packaged with the IOS
firmware had the incorrect version.
Appendix D
Error and Event Messages
Recommended Action
None.
None.
None.
None.
None.
None.
None.
Make sure file is a valid HTML page. If
so, you'll have to copy an
uncompressed version of the file into
Flash to retrieve it through HTTP.
None.
None.
None.
None.
OL-4059-01
Advertisement
Table of Contents
