Modify Routing Policy Using Text Editor - Cisco NCS 5500 Series Configuration Manuals

Modify Routing Policy Using Text Editor

4. address-family { ipv4 unicast | ipv4 labeled-unicast | ipv4 tunnel | ipv4 mdt | ipv6 unicast |
ipv6 labeled-unicast } address-family { ipv4 | ipv6 } unicast
5. route-policy policy-name { in | out }
6. commit
DETAILED STEPS
Step 1
configure
Step 2
router bgp as-number
Example:
RP/0/RP0/CPU0:router(config)# router bgp 125
Configures a BGP routing process and enters router configuration mode.
• The as-number argument identifies the autonomous system in which the router resides. Valid values are from 0 to
65535. Private autonomous system numbers that can be used in internal networks range from 64512 to 65535.
Step 3 neighbor ip-address
Example:
RP/0/RP0/CPU0:router(config-bgp)# neighbor 10.0.0.20
Specifies a neighbor IP address.
Step 4 address-family { ipv4 unicast | ipv4 labeled-unicast | ipv4 tunnel | ipv4 mdt | ipv6 unicast | ipv6 labeled-unicast
} address-family { ipv4 | ipv6 } unicast
Example:
RP/0/RP0/CPU0:router(config-bgp-nbr)# address-family ipv4 unicast
Specifies the address family.
Step 5
route-policy policy-name { in | out }
Example:
RP/0/RP0/CPU0:router(config-bgp-nbr-af)# route-policy example1 in
Attaches the route-policy, which must be well formed and predefined.
Step 6
commit
Modify Routing Policy Using Text Editor
This task explains how to modify an existing routing policy using a text editor.
Routing Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release 6.3.x
130
Implementing Routing Policy