1-Port Channelized Stm-1/Oc-3 Spa Interface Specifications; 1-Port Channelized Stm-1/Oc-3 Spa Cables And Connectors - Cisco XR 12000 Series Hardware Installation Manual

Router sip and spa
Hide thumbs Also See for XR 12000 Series:
Table of Contents

Advertisement

1-Port Channelized STM-1/OC-3 SPA Overview
The 1-Port Channelized STM-1/OC-3 SPALEDs are described in
Table 2-27
LED Label
C/A
A/L
STATUS

1-Port Channelized STM-1/OC-3 SPA Interface Specifications

The framer processes incoming and outgoing SONET or SDH frames. The framer operates at
OC-3/STM-1 line rates (155.52 Mbps).
Packet data is transported with a user-configured encapsulation (such as Point-to-Point Protocol [PPP])
and is mapped into the STS-3/STM-1 frame.
The 1-Port Channelized STM-1/OC-3 SPA interface is compliant with RFC 1619, PPP over
SONET/SDH, and RFC 1662, PPP in HDLC-like Framing. The 1-Port Channelized STM-1/OC-3 SPA
also provides support for SNMP v1 agent (RFC 1155–1157), and Management Information Base (MIB)
II (RFC 1213).
The 1-Port Channelized STM-1/OC-3 SPA supports Frame Relay Fragmentation (FRF.12) and Multilink
Note
Fame Relay (MFR) features for Cisco IOS XR Software Release 3.6.0 and later releases.

1-Port Channelized STM-1/OC-3 SPA Cables and Connectors

The 1-Port Channelized STM-1/OC-3 SPA uses a small form-factor pluggable (SFP) optical transceiver
module installed in each port for SONET and SDH single-mode and multimode optical fiber connection
(see
Cisco XR 12000 Series Router SIP and SPA Hardware Installation Guide
2-30
1-Port Channelized STM-1/OC-3 SPA LEDs
Color
State
Off
Off
Green
On
Amber
On
Off
Off
Green
On
Amber
On
Off
Off
Green
On
Amber
On
Figure
2-17).
Chapter 2
Overview: Cisco XR 12000 Series Router Shared Port Adapters
Table
Meaning
Port is not enabled by software.
Port is enabled by software, and there is a valid T3 signal
without any alarms.
Port is enabled by software, and there is at least one alarm.
Port is not enabled by software.
Port is enabled by software, loopback is off.
Port is enabled by software, loopback is on.
SPA power is off.
SPA is ready and operational.
SPA power is on and good, and SPA is being configured.
2-27.
OL-17438-04

Advertisement

Table of Contents
loading

Table of Contents