Initial Start-Up Procedure - BENDIX EC-17 ANTILOCK TRACTION CONTROL Manual

ANTILOCK DASH LAMP DOES
NO
NOT BLINK, COMES ON AND
REMAINS ILLUMINATED
GO TO SECTION II "INSPECTION
FOR ILLUMINATED LEDS"
ANTILOCK DASH LAMP DOES
NOT BLINK, DOES NOT COME
ON. GO TO SECTION I.
THE ANTILOCK SYSTEM IS
FUNCTIONING NORMALLY. MAKE
NOTE OF ANY PARTS REPLACED OR
REPAIRED.
If the EC-17 ™ controller has been recently replaced, make
certain it is configured properly for the vehicle. If traction
control is part of the configuration, the "enable - disable"
switch must be toggled after power has been applied to
the EC-17 ™ controller and before self configuring process
(traction control operable).

INITIAL START-UP PROCEDURE

START HERE
NO
YES
INCREASE VEHICLE SPEED TO ABOVE 7
NO
GO TO SECTION X
"TESTING THE TRACTION
DASH LAMP"
TURN IGNITION ON AND
OBSERVE DASH ANTILOCK
LAMP.
DID ANTILOCK DASH LAMP BLINK?
YES
IS ANTILOCK DASH LAMP
STILL ILLUMINATED?
NO
MPH FOR AT LEAST 10 SECONDS AND
OBSERVE THE DASH LAMP.
DASH LAMP ILLUMINATES
NO
IS VEHICLE EQUIPPED WITH
TRACTION CONTROL?
YES
TURN IGNITION OFF THEN
ON AND OBSERVE ONLY
THE TRACTION CONTROL
DASH LAMP. DID TRACTION
CONTROL LAMP BLINK THEN
GO OUT?
NO
MAKE CERTAIN TRACTION
IS ENABLED (WITH VEHICLE
STATIONARY, LOCATE & ACTI-
VATE THE REMOTE TRACTION
ENABLE SWITCH). RETEST
DID TRACTION CONTROL
LAMP GO OUT?
NO
NO
IS TRACTION DASH
LAMP ILLUMINATED?
YES
GO TO SECTION III
"INSPECTION FOR
ILLUMINATED
LEDs"
YES
mid-year
AFTER
SERIAL COMMAND NEEDS
YES
TO BE SEEN ON THE J1922
OR J1939 LINK FOR TRAC-
TION TO FUNCTION
THE TRACTION SYSTEM IS
FUNCTIONING NORMALLY.
YES
GO TO SECTION XI
YES
"TESTING TRACTION
CONTROL MODULATOR"
2000 A
17