BENDIX EC-17 ANTILOCK TRACTION CONTROL Manual page 29

SECTION X - TESTING TRACTION CONTROL DASH LAMP
NO
REPLACE TRACTION DASH LAMP WITH
IS THIS THE SECOND TIME TO
START HERE
KNOWN GOOD UNIT. REPEAT "INITIAL
THIS POINT?
START-UP PROCEDURE"
YES
C2
WITH IGNITION OFF, REMOVE 30 PIN
CONNECTOR FROM EC-17 ™ CONTROLLER.
1
TURN IGNITION ON AND CHECK FOR
2
VEHICLE VOLTAGE AT TERMINAL C2.
3
K J H G F E D C B A
30 PIN CONNECTOR
YES
VEHICLE VOLTAGE
REPLACE EC-17 ™
DETECTED?
CONTROLLER
NO
REPAIR OR REPLACE WIRE
HARNESS AND RETEST
VEHICLE
NO
OR ECU BUILT
AFTER
mid-year
2000
YES
ECU REQUIRES TORQUE REQUEST VIA
J1922 OR J1939 SERIAL LINK WITHIN 5
MINUTES OF IGNITION KEY ON OR THE
TRACK CONTROL LAMP WILL COME ON
29