Switchport Access - Brocade Communications Systems 1606 Reference

switchport access

Sets the Layer 2 interface as access.
Synopsis switchport access vlan vlan_id
no switchport access vlan
Operands vlan vlan_id
Defaults By default, all Layer 2 interfaces are in access mode and belong to the VLAN ID 1.
Command Interface configuration mode
Modes
Description Use this command to set the Layer 2 interface as access. In access mode, the interface only allows
untagged and priority tagged packets. Use the no switchport access vlan command to set the PVID
to the default VLAN 1.
Usage There are no usage guidelines for this command.
Guidelines
Examples To set the Layer 2 interface PVID to 100:
See Also show vlan brief, show interface switchport, switchport mode, switchport trunk
Converged Enhanced Ethernet Command Reference
53-1001762-01
DRAFT: BROCADE CONFIDENTIAL
Sets the port VLAN (PVID) to the specified vlan_id. The range of valid values is
1-3583.
switch(conf-if-te-0/19)#switchport access vlan 100
switchport access
49
3