Dot1X Timeout Tx-Period - Brocade Communications Systems 1606 Reference

dot1x timeout tx-period

Sets the number of seconds that the switch waits for a response to an Extensible Authentication
Protocol (EAP) request or identity frame from the client before retransmitting the request.
Synopsis dot1x timeout tx-period seconds
Operands seconds
Defaults The default timeout is 30 seconds.
Command Interface configuration mode
Modes
Description Use this command to set the interval between successive attempts to request an ID (EAP ID Req).
Usage There are no usage guidelines for this command.
Guidelines
Examples To set 34 as the number of seconds to wait for a response to an EAP-request or identity frame from
the client before retransmitting the request:
See Also none
Converged Enhanced Ethernet Command Reference
53-1001762-01
DRAFT: BROCADE CONFIDENTIAL
Specifies the time in seconds between successive request ID attempts. The
range of valid values is 1-65535.
switch(config)#interface tengigabitethernet 0/1
switch(config-if)#dot1x timeout tx-period 34
dot1x timeout tx-period
13
227