Exec-Timeout - Brocade Communications Systems 1606 Reference

2

exec-timeout

exec-timeout
Sets the interval that the EXEC command interpreter wait for user input.
Synopsis exec-timeout minutes seconds
no exec-timeout
Operands minutes
seconds
Defaults The default is 10 minutes.
Command Console and VTY (line) configuration mode
Modes
Description Use this command to set the interval; the command interpreter waits for user input detected. Use
no exec-timeout to disable the wait interval that the command interpreter waits.
Usage The exec-timeout command is used to set the time the Telnet session waits for an idle VTY session,
Guidelines before it time outs. An exec-timeout setting of 0 (zero) causes the Telnet session to wait indefinitely.
Examples To configure the wait interval for the console session:
See Also show line, line vty, line console
14
DRAFT: BROCADE CONFIDENTIAL
Specifies the time interval in minutes. The range is 0-35791.
Specifies the time interval in seconds. The range is 0-2147483.
switch(config)#line console 0
switch(conf-line)#exec-timeout 2 30
switch(config)#line vty 0 9
switch(conf-line)#exec-timeout 30 30
Converged Enhanced Ethernet Command Reference
53-1001762-01