QoS Commands
cee
Applies a CEE Provisioning map on an interface.
Synopsis
cee name
no cee
Operands
name
Defaults
There is no CEE Provisioning applied on an interface.
Command
Interface configuration mode
Modes
Description
Use this command to apply a CEE map on an interface. Use the no cee command to remove the
CEE Provisioning map.
Usage
The CEE map applied on an interface should exist on the switch.
Guidelines
Examples
To apply a CEE map on an interface:
Because the switch does not allow applying a CEE map that does not exist, the following error
displays:
See Also
cee-map
Converged Enhanced Ethernet Command Reference
53-1001762-01
DRAFT: BROCADE CONFIDENTIAL
Specifies the name of a previously created CEE map. Any existing CEE map
must be removed before a new one can be applied.
switch(conf-if-te-0/1)#cee demo
switch(conf-if-te-0/1)#cee test
% Error: Map does not exist
Chapter
12
189