4. In the Manager (SNMP Browser), create a user fa_adm with Authentication protocol as MD5,
Brocade 7500 / FR4-18i and Brocade MIBs
Beginning with release Fabric OS 5.3.0, statistics are available for FCIP tunnels, VEX_Ports, or
VE_Ports through the portstatsshow command.
The changes in the sensor details for FR4-18i Blade has been incorporated into SNMP. The
"connUnitSensorTable 1.3.6.1.3.94.1.8"
1.3.6.1.4.1.1588.2.1.1.1.1.22"
sensorShow command.
Access Gateway and Brocade MIBs
Brocade Access Gateway supports the following MIBs.
TABLE 3
MIB name
MIB-2
Entity-MIB
HA MIB
SW-MIB
FA-MIB
FE-MIB
CPQ-Rack MIB
FCIP MIB
iSCSI MIB
Firmware upgrades and enabled traps
Prior to Fabric OS v4.4, traps were turned on and off as a group (for example, the SW-Trap, or
FA-Trap). In these versions of the Fabric OS it was not possible to set individual traps (such as,
swSensorStatusChangeTrap, swTrackChangesTrap, or connUnitEventTrap).
Fabric OS MIB Reference
53-1001339-01
GET security level = 2, SET level = 2
SNMP GET Security Level: Authentication and Privacy
SNMP SET Security Level: Authentication and Privacy
Privacy protocol as DES, set the password and set the trap port as 65000. (Same values are
set as in the switch SNMPv3 configuration.)
Access Gateway MIB support
Supported
Yes
Yes
Yes
No
Yes
No
Limited
Limited
Limited
Brocade 7500 / FR4-18i and Brocade MIBs
on page 225 and
on page 150 display information consistent with the Fabric OS
Description
Updated to support Access Gateway in v5.2.1.
Disabled in Access Gateway because the conventions are specific to
fabric switches.
The connUnitSnsTable is not supported because a switch in Access
Gateway does support name server services.
Disabled in Access Gateway because the conventions are specific to
fabric switches.
Supported on embedded switches only.
Implemented to support WAN interfaces in Fabric OS v5.3.0.
Supports displaying information about virtual targets (VTs), iSCSI
sessions, and TCP connection tables, as derived from specific MIB
tables.
"swSensorTable
1
13