Ficon Commands - Brocade Communications Systems 1606 Administrator's Manual

FICON commands

NOTE
The Fabric OS CLI supports only a subset of the Brocade management features for FICON fabrics.
The full set of FICON CUP administrative procedures is available using the Brocade Data Center
Fabric Manager and Web Tools software features. You can also use an SNMP agent and the FICON
Management Information Base (MIB).
Table 1
For detailed information on these commands, see the Fabric OS Command Reference.
TABLE 1
Command
Standard Fabric OS commands
Commands specific to FICON
FICON Administrator's Guide
53-1001771-01
summarizes the Fabric OS CLI commands that can be used for managing FICON fabrics.
Fabric OS commands related to FICON
bladeSwap
configure
configUpload
firmwareShow
licenseAdd
portAddress --bind
portAddress --unbind
portSwap
portSwapDisable
portSwapEnable
portSwapShow
supportShowCfgEnable ficon
ficonclear rlir
ficonclear rnid
ficoncfg set LIRR <portnumber>
--
ficoncfg reset LIRR <portnumber>
--
ficonshow ilir [fabric]
ficonshow lirr [fabric]
ficonshow rlir [fabric]
Description
Swaps the area numbers for matching port pairs of two blades.
Sets the domain ID and the insistent domain ID mode.
Backs up the current configuration.
Displays the current version of the firmware.
Adds a license to the switch. The license key is case sensitive and
must be entered exactly.
Binds the 16-bit address to the lower two bytes of a port 24-bit
Fibre Channel address.
Unbinds the currently bound address for the specified port.
Swaps ports.
Disables the portSwap command.
Enables the portSwap command.
Displays information about swapped ports.
Turns on logging of FICON information on the switch.
Removes all RLIR records from the local RLIR database.
Removes all outdated RNID records from the local RNID
database.
Sets the current LIRR device port number persistently.
Clears the currently configured LIRR port number.
Displays FRU failure information on the local switch or on the
fabric, if specified.
Displays registered listeners for link incidents for the local switch
or for the fabric, if specified.
Displays link incidents for the local switch or for the fabric, if
specified.
FICON commands
1
13