Removing Zones (Members) From A Zone Configuration; Enabling A Zone Configuration - Brocade Communications Systems 1606 Administrator's Manual

Example

Removing zones (members) from a zone configuration

1. Connect to the switch and log in as admin.
2. Enter the cfgRemove command, using the following syntax:
3. Enter the cfgSave command to save the change to the defined configuration.
Example

Enabling a zone configuration

The following procedure ends and commits the current zoning transaction buffer to nonvolatile
memory. If a transaction is open on a different switch in the fabric when this procedure is run, the
transaction on the other switch is automatically aborted. A message displays on the other switches
to indicate that the transaction was aborted.
1. Connect to the switch and log in as admin.
2. Enter the cfgenable command, using the following syntax:
3. Enter y at the prompt.
Example
Fabric OS Administrator's Guide
53-1001763-01
The cfgSave command ends and commits the current zoning transaction buffer to nonvolatile
memory. If a transaction is open on a different switch in the fabric when this command is run,
the transaction on the other switch is automatically aborted. A message displays on the other
switches to indicate that the transaction was aborted.
switch:admin> cfgadd "newcfg", "bluezone"
switch:admin> cfgsave
You are about to save the Defined zoning configuration. This
action will only save the changes on the Defined configuration.
Any changes made on the Effective configuration will not
take effect until it is re-enabled.
Do you want to save Defined zoning configuration only? (yes, y, no, n): [no] y
cfgremove "cfgname", "member[; member...]"
The cfgSave command ends and commits the current zoning transaction buffer to nonvolatile
memory. If a transaction is open on a different switch in the fabric when this command is run,
the transaction on the other switch is automatically aborted. A message displays on the other
switches to indicate that the transaction was aborted.
switch:admin> cfgremove "NEW_cfg", "purplezone"
switch:admin> cfgsave
You are about to save the Defined zoning configuration. This
action will only save the changes on the Defined configuration.
Any changes made on the Effective configuration will not
take effect until it is re-enabled.
Do you want to save Defined zoning configuration only? (yes, y, no, n): [no] y
cfgenable "cfgname"
switch:admin> cfgenable "USA_cfg"
You are about to enable a new zoning configuration.
This action will replace the old zoning configuration with the
current configuration selected. If the update includes changes
Zoning configurations
11
255