Configuration File Format - Brocade Communications Systems 1606 Administrator's Manual

8
Configuration settings
CAUTION
Editing of the uploaded file is unsupported and can result in system errors if an edited file is
subsequently downloaded.
If you have the chassis role permissions added to your user account, then the following options are
available whether you are uploading or downloading a configuration file:
-fid
-all
-chassis

Configuration file format

The configuration file is divided into three areas: the header, the chassis section, and one or more
switch sections. If you upgrade the firmware on any existing switches from pre-Fabric OS v6.2.0 to
v6.2.0, then you must perform the configUpload command to upload both chassis and switch
information.
CAUTION
If you have Virtual Fabrics enabled, you must follow the procedure in
for Virtual Fabrics"
Example of a configuration file
176
Uploads the specified FID configuration.
Uploads all of the system configuration, including the chassis section and
all switch sections for all logical switches.
Note: Use this parameter when obtaining a complete capture of the switch
configuration in a switch that has Virtual Fabric mode disabled.
Uploads only the chassis section of the system configuration file.
on page 184 to restore the logical switches.
[Configuration upload Information]
Configuration Format = 2.0
date = Thu Apr 2 21:28:52 2009
FOS version = v6.3.0.0
Number of LS = 2
[Chassis Configuration Begin]
[fcRouting]
[Chassis Configuration]
[LicensesDB]
[Bottleneck Configuration]
[DMM_WWN]
[Licenses]
[Chassis Configuration End]
date = Thu Apr 2 21:28:52 2009
"Configuration management
Fabric OS Administrator's Guide
53-1001763-01