Broadcast Zones And Fc-Fc Routing; Figure 33 Broadcast Zones And Admin Domains - Brocade Communications Systems 1606 Administrator's Manual

Fabric os administrator's guide v6.4.0 (53-1001763-01, june 2010)
Hide thumbs Also See for 1606:
Table of Contents

Advertisement

Figure 33
five devices and two Admin Domains, AD1 and AD2. Each Admin Domain has two devices and a
broadcast zone.
"5,1"
FIGURE 33
The dotted box represents the consolidated broadcast zone, which contains all of the devices that
can receive broadcast packets. The actual delivery of broadcast packets is also controlled by the
Admin Domain and zone enforcement logic. The consolidated broadcast zone is not an actual zone,
but is just an abstraction used for explaining the behavior.
When a switch receives a broadcast packet it forwards the packet only to those devices which are
zoned with the sender and are also part of the consolidated broadcast zone.
You can check whether a broadcast zone has any invalid members that cannot be enforced in the
current AD context. Refer to

Broadcast zones and FC-FC routing

If you create broadcast zones in a metaSAN consisting of multiple fabrics connected through an FC
router, the broadcast zone must include the IP device that exists in the edge or backbone fabric as
well as the proxy device in the remote fabric. See
for information about proxy devices and the FC router.
Fabric OS Administrator's Guide
53-1001763-01
illustrates how broadcast zones work with Admin Domains.
"1,1"
AD1
broadcast
"1,1; 3,1; 5,1"
"1,1"
Broadcast zones and Admin Domains
The broadcast zone for AD1 includes member devices "1,1", "3,1" and "5,1"; however, "3,1"
and "5,1" are not members of AD1. Consequently, from the AD1 broadcast zone, only "1,1" is
added to the consolidated broadcast zone.
The broadcast zone for AD2 includes member devices "2,1", "3,1", and "4,1". Even though
"2,1" is a member of AD1, it is not a member of AD2 and so is not added to the consolidated
broadcast zone.
Device "3,1" is added to the consolidated broadcast zone because of its membership in the
AD2 broadcast zone.
"Validating a zone"
"2,1"
AD2
broadcast
"1,1; 3,1; 4,1"
on page 251 for complete instructions.
Chapter 21, "Using the FC-FC Routing Service,"
Broadcast zones
Figure 33
shows a fabric with
"3,1"
"4,1"
broadcast
"2,1; 3,1; 4,1"
"3,1; 4,1"
11
245

Advertisement

Table of Contents
loading

This manual is also suitable for:

8/248/408/88/80

Table of Contents