Configuring Zones On The Switch; Specifying Devices - Brocade Communications Systems 1606 Administrator's Manual

2
Configuring the switch
.
FIGURE 14
Typical Zoning is the default and the following procedure directs you to select Typical Zoning. When
you select Typical Zoning, the wizard automatically configures the zones for you and shows you
how to connect the devices to the switch. You can change the zoning configuration later, as
described in

Configuring zones on the switch

1. On the Select Zoning wizard, select Typical Zoning.
2. Click Next.

Specifying devices

On the Specify Devices screen
1. Enter the number of HBA connections that you want to attach to the switch. Be sure to include
2. Enter the number of storage connections you want to attach to the switch. Be sure to include
18
Select Zoning wizard
"Zoning management"
If you want to use one of the other zone settings, see
page 43 for instructions on configuring Custom zoning; see the Web Tools Administrator's
Guide for information on Advanced zoning.
The Specify Devices screen is displayed.
existing HBA connections, and any additional HBA connections you plan to make in the current
setup session. You can change this setting later if you want to add or remove HBA connections.
existing storage connections, and any additional storage connections you plan to make in the
current setup session.You can change this setting later if you want to add or remove storage
connections.
on page 42.
(Figure 15), do the following.
"Editing the zoning configuration"
EZSwitchSetup Administrator's Guide
on
53-1001344-01