Table 42 Cli Commands To Display Or Modify Switch Configuration Information - Brocade Communications Systems 1606 Administrator's Manual

-all
In case something happens to your switch and you need to set it up again, run the commands listed
in Table 42
reference.
TABLE 42
Command
configShow
fcLunQuery
fcrRouterPortCost
fcrXlateConfig
fosConfig
ipAddrShow
iscsiCfg
iscsiPortCfg
iscsiTargetName
isnscCfg
licenseShow
portCfgEXPort
portCfgVEXPort
Fabric OS Administrator's Guide
53-1001763-01
The number of switches or FIDs defined in the downloaded configuration file
must match the number of switches or FIDs currently defined on the switch.
The switches must be disabled, if necessary (refer to
without disabling a switch"
configuration downloads). If they are not, the configDownload command
downloads the configuration for as many switches as possible until a
non-disabled switch is encountered. Then it will stop. Before running this
command, verify if any switches need to be disabled. If you are performing a
configDownload due to a configuration error, it is highly recommended to
perform a configDefault before running the configDownload command.
In Virtual Fabric-enabled mode, the chassisDisable and chassisEnable
commands are used to disable all logical switches on the affected switch. This
bypasses the need to disable and enable each switch individually once the
configuration download has completed.
Non-Virtual Fabric configuration files downloaded to a Virtual Fabric system will
only have configuration applied to the default switch. If there are multiple logical
switches created in a Virtual Fabric-enabled system, there could be some issues
if there are ports that belong to the default switch in a Virtual Fabric-disabled
system, but are now assigned to logical switches in a Virtual Fabric-enabled
system. Only configurations related to ports within the default switch will be
applied.
and save the output in a file format. Store the files in a safe place for emergency
CLI commands to display or modify switch configuration information
Displays
System configuration parameters and settings, and license information.
A list of LUN IDs and LUNs for all accessible targets.
FC Router route information.
A translate (xlate) domain's domain ID for both EX_Port-attached fabric and backbone fabric.
Fabric OS features.
The IP address.
iSCSI entities.
The iSCSI port parameters.
The IQN prefix.
The configuration state of the iSNS client operation.
The license keys you have installed and provides better detail than the license information
from the configShow command.
EX_Port configuration parameters.
VEX_Port configuration parameters.
Configuration file restoration
on page 182 for more information on non-disruptive
8
"Configuration download
181