Deleting End-To-End Monitors - Brocade Communications Systems 1606 Administrator's Manual

17
End-to-end performance monitoring
Figure 60
compare the AL_PA fields on the SID and DID in all frames (transmitted and received) on port 2.
The frame SID and DID must match only the AL_PA portion of the specified SID-DID pair. Each port
can have only one EE mask. The mask is applied to all end-to-end monitors on the port. Individual
masks for each monitor on the port cannot be specified.
perfsetporteemask 1/2, "00:ff:ff" "00:ff:ff" "00:ff:ff" "00:ff:ff"
FIGURE 60

Deleting end-to-end monitors

1. Connect to the switch and log in as admin.
2. Enter the perfMonitorShow command to list the valid end-to-end monitor numbers for a port.
3. Enter the perfDelEEMonitor command to delete a specific monitor.
Example
The following example displays the end-to-end monitors on port 0 (the monitor numbers are listed
in the KEY column) and deletes monitor number 2 on port 0:
switch:admin> perfmonitorshow --class EE 0
There are 4 end-to-end monitor(s) defined on port
KEY SID DID
--------------------------------------------------------------------------------------
0 0x000024 0x000016
1 0x000022 0x000033
2 0x000123 0x000789
3 0x001212 0x003434
switch:admin> perfdeleemonitor 0, 2
End-to-End monitor number 2 deleted
switch:admin>
388
shows the mask positions in the command. A mask ("ff") is set on slot 1, port 2 to
Mask positions for end-to-end monitors
If you do not specify which monitor number to delete, you are asked if you want to delete all
entries.
OWNER_APP TX_COUNT
WEB_TOOLS 0x0000000000000000
WEB_TOOLS 0x0000000000000000
WEB_TOOLS 0x0000000000000000
WEB_TOOLS 0x0000000000000000
Transmitted from port
SID mask DID mask
AL_PA mask
Area ID mask
Domain ID mask
0.
RX_COUNT
0x0000000000000000
0x0000000000000000
0x0000000000000000
0x0000000000000000
Received by port
SID mask DID mask
OWNER_IP_ADDR
10.106.7.179
10.106.7.179
10.106.7.179
10.106.7.179
Fabric OS Administrator's Guide
53-1001763-01