Changing The State Of A Ti Zone - Brocade Communications Systems 1606 Administrator's Manual

3. Enter the cfgEnable command to reactivate your current effective configuration and enforce
Example of modifying a TI zone
To add port members to the existing TI zone bluezone:
To add port members to the existing TI zone in a backbone fabric:
To disable failover on the existing TI zone bluezone:
To enable failover and add ports to TI zone greenzone:
To remove ports from the TI zone bluezone:
Remember that your changes are not enforced until you enter the cfgEnable command.

Changing the state of a TI zone

You can change the state of a TI zone to activated or deactivated. Changing the state does not
activate or deactivate the zone. After you change the state of the TI zone, you must enable the
current effective configuration to enforce the change.
The TI zone must exist before you can change its state.
1. Connect to the switch and log in as admin.
2. Perform one of the following actions:
3. Enter the cfgEnable command to reactivate your current effective configuration and enforce
Example of setting the state of a TI zone
To change the state of the existing TI zone bluezone to activated, type:
To change the state of the existing TI zone greenzone to deactivated, type:
Remember that your changes are not enforced until you enter the cfgEnable command.
Fabric OS Administrator's Guide
53-1001763-01
Be aware of the ramifications if you disable failover mode. See
for information about disabling failover mode.
the TI zones.
cfgenable "current_effective_configuration"
switch:admin> zone --add bluezone -p "3,4; 3,6"
switch:admin> zone --add backbonezone -p "3,4; 3,6; 10:00:00:04:1f:03:16:f2;"
switch:admin> zone --add -o n bluezone
switch:admin> zone --add -o f greenzone -p "3,4"
switch:admin> zone --remove bluezone -p "3,4; 3,6"
•
To activate a TI zone, enter the zone
zone --activate name
•
To deactivate a TI zone, enter the zone
zone --deactivate name
the TI zones.
cfgenable "current_effective_configuration"
switch:admin> zone --activate bluezone
switch:admin> zone --deactivate greenzone

Changing the state of a TI zone

"TI zone failover"
activate command.
--
deactivate command.
--
12
on page 268
285