Table of Contents
Advertisement
MIB II
E
ipRouteIfIndex
ipRouteMetric1
ipRouteMetric2
E/OS SNMP Support Manual
E-26
Description
The destination IP address of this route. An entry with a value of
0.0.0.0 is considered a default route. Multiple routes to a single
destination can appear in the table, but access to such multiple entries
is dependent on the table-access mechanisms defined by the network
management protocol in use.
Sequence
::= { ipRouteEntry 1 }
Syntax
INTEGER
Access
read-write
Status
mandatory
Description
The index value which uniquely identifies the local interface through
which the next hop of this route should be reached. The interface
identified by a particular value of this index is the same interface as
identified by the same value of ifIndex.
Sequence
::= { ipRouteEntry 2 }
Syntax
INTEGER
Access
read-write
Status
mandatory
Description
The primary routing metric for this route. The semantics of this
metric are determined by the routing-protocol specified in the route's
ipRouteProto value. If this metric is not used, its value should be set
to -1.
Sequence
::= { ipRouteEntry 3 }
Syntax
INTEGER
Access
read-write
Status
mandatory
Description
An alternate routing metric for this route. The semantics of this
metric are determined by the routing-protocol specified in the route's
Advertisement
Table of Contents
