Program Change; Parameter Change - Yamaha DME64N - Pro Audio Owner's Manual

Digital mixing engine
Hide thumbs Also See for DME64N - Pro Audio:
Table of Contents

Advertisement

Utility Displays
NOT E
"DAW" stands for "Digital Audio Workstation." ProTools, Logic,
and Cubase are DAW applications, and this parameter provides
direct compatibility with a number of physical controls surfaces
that are available for use with these DAW software packages.
The following parameters are available when the DAW
parameter is set to OFF.
3 CH
Specifies the device's MIDI transmit and receive channel:
1 ~ 16.
Edit using the "List Parameters" editing procedure
described on page 38.

4 Program Change

Turns transmission and reception, the omni mode, and
echo ON or OFF for MIDI program change messages.
Move the cursor to the required parameter, then press the
[ENTER] key to alternately turn ON and OFF.
5 Control Change
Turns transmission and reception, the omni mode, and
echo ON or OFF for MIDI control change messages.
Move the cursor to the required parameter, then press the
[ENTER] key to alternately turn ON and OFF.

6 Parameter Change

Turns transmission and reception, and echo ON or OFF
for MIDI parameter change messages.
Move the cursor to the required parameter, then press the
[ENTER] key to alternately turn ON and OFF.
52
DME64N/DME24N Owner's Manual
DAW Control
1. Parameter Control Function
Lets you control DME64N/24N parameters using a
DAW Controller.
For example, if the PAN parameter is assigned to CH1
of the DAW controller, you can control the PAN
parameter by operating a knob.
There are two modes in the parameter control function,
as follows:
(1) General Parameter Operation Mode
[KNOB] and [CH FADER] controls are used to
operate internal parameters assigning them in DME
Designer.
For detailed settings, see the "DME Designer Owner's
Manual."
(2) Final Output Stage Parameter Operation Mode
Final output stage parameters are operated using
[MUTE] and [CH FADER] controls.
Unlike the General Parameter Control Mode, controls
and the parameters that are compatible with them, are
fixed in this mode.
[Method of Operation]
[▲]: Switches to General Internal Parameter Control
Mode.
[▼]: Switches to Final Output Stage Parameter Control
Mode.
[BANK <][BANK >]: The channels targeted for
operation are shifted by the number of channels built
into the DAW controller.
[CH <][CH >]: The channels targeted for operation are
shifted one channel at a time.
[SELECT]: Switches the display method on the DAW
controller.
When turned OFF, an overall display appears. When a
channel is turned ON, the detail display appears for
that channel.
For information about the overall and detail displays,
see the next item, "Setting and Parameter Name
Display Function."
[KNOB]: Changes assigned parameters in the General
Internal Parameter Operation Mode.
This is not used in the Final Output Stage Parameter
Operation Mode.
[MUTE]: This is not used in the General Internal
Parameter Operation Mode.
This turns muting ON or OFF for the corresponding
channel in the Final Output Stage Parameter Operation
Mode.
[CH FADER]: Changes assigned parameters in the
General Internal Parameter Operation Mode.
This adjusts volume for the corresponding channel in
the Final Output Stage Parameter Operation Mode.
N OTE
Only one parameter can be assigned to the same channel.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dme24n

Table of Contents